Turn PNP machine power on (main rotary switch, bottom right-hand side)

Power up PNP motor controller (green button on the tray front)

Start the 'smt' application

When asked, press <Space> to start homing calibration, this might take a while depending on the current X/Y position of the placer head

Open a demo file, 'bgatest' is good enough

When asked, select the default mode '0' (just hit <Enter>)

From the '??????' menu select 'Manueller Modus'

Freak out (aka: use below keys to do manual stuff and amaze people)

Press <ESC>

From the 'Datei' menu select 'Beeenden'

Turn off machine using mains switch